16-channel GNSS antenna splitter
Product information "16-channel GNSS antenna splitter"
In several use cases there is a need for providing a GPS reference signal to a variety of device with built-in receivers. Running separate Antenna cables to each of those GPS receivers is often difficult and cumbersome.
This includes, for example
lab setups where many cellular base stations with GPS clock reference input are operated
lab setups wit a variety of measurement devices that utilized GPS disciplined reference clocks
in-building distribution of GPS RF signals
The sysmocom 16-channel GPS antenna RF splitter is the ideal solution for such setups. Its unparalleled number of 16 receiver-side RF ports allow for a large density of GPS receivers.
The GPS RF signal of a single GPS antenna (which can optionally be phantom powered by the splitter) is filtered, amplified, filtered again and then split (in two stages of 1:4 dividers) across 16 RF outputs.
Each output features an integrated DC-block and a dedicated LED to indicate if phantom voltage is supplied by the attached receiver or not. Supported biasing voltages on the output side are in the range of 3 .. 12V DC.
The product is available in two form-factors
a stand-alone extruded aluminum desktop enclosure - useful for portable operation on a lab desk (gps-spl-16-koh)
as a module for a 3U component carrier - a perfect fit for larger rack-mounted lab installation or in-building GPS RF signal distribution (gps-spl-16-bgt)
The product does not include a 12V DC power supply. Please see below product links should you want a power supply included:
Further Links
Login
Accessories
GPS antenna with 3m coaxial cable and SMA male connector.Suitable as accessory to a variety of sysmocom products, includingindoor sysmoBTS models with optional GPS receiverGPS receiver evaluation boardsicE1usb E1 interface with built-in GPS-DO
This is a desktop-type AC power suppy for 12V DC / 3A output.It is a suitable as a accessory (or replacement part) for the following productssysmoQMODgps-spl16NOTE: There is no primary AC cable included, please provide one yourself or check the accessories listed below under C7 cablesAC Input100-240V AC, +/-10%, 47-63 HzInput Currrent100V AC: 0.45AInrush currentlimited to 60A peakEfficiencyMeets EISA2007, CEC Efficiency Level V,EU (EC) No 278/2009 Phase IOutput Voltage12VOutput Current3A (max)Output Ripple1 .. 6% MTBF50,000 hours (calculated)Operating Temperature0 to 40 centigrade, no deratingOutput Connector2.5mm barrel type, center contact +Output Cable1.5m +/- 5cmInput ConnectorICE320 - C8
This is a desktop-type AC power suppy for 5V DC / 3A output.It is a suitable as a replacement part for the following products:sysmoBTS 1002 (indoor version)But can of courase also be used as accessory for other products likeminiPCIe breakout boardM.2 modem carrier with remote SIM / tracingNOTE: There is no primary AC cable included, please provide one yourself or check the accessories listed below under C7 cablesAC Input100-240V AC, +/-10%, 47-63 HzInput Currrent100V AC: 0.45AInrush currentlimited to 60A peakInput FuseInternal Fuse 3.15A, 250V ACEfficiencyMeets EISA2007, CEC Efficiency Level V,EU (EC) No 278/2009 Phase IOutput Voltage5VOutput Current3A (max)Output Ripple50mV peak-peak (max)MTBF100,000 hours (calculated)Operating Temperature0 to 40 centigrade, no deratingOutput Connector2.5mm barrel type, center contact +Output Cable1.5m +/- 5cmInput ConnectorICE320 - C8