GPS antenna with 3m coaxial cable and SMA male connector.Suitable as accessory to a variety of sysmocom products, includingindoor sysmoBTS models with optional GPS receiverGPS receiver evaluation boardsicE1usb E1 interface with built-in GPS-DO
This is a PCB antenna which can be soldered as SMT part on your custom circuit board.824 .. 960 MHz; 1710 - 1990 MHz50 Ohms impedance37.59 x 11.94 x 1.57 mmThis small embedded
antenna provides the most
reliable easy-to-use, and
technology for handling
during assembly and
developers.Minimum or no matching
circuits required.Bandwidth and performance
is dependent on ground
plane size. Suggested
minimum ground plane
length from the antenna
feed is 100 mm.PCB ground is to be on top
layer.Product Homepage: https://www.te.com/usa-en/product-1513259-1.html
Marine GNSS (includes GPS) antenna with 3m coaxial cable and N male connector.Intended to be mounted on top of a threaded water pipe (as mast) on boats.Bandwidth10 MHzNoise Figure2 dB typ.Supply Volage2.3 .. 5.5 V DCCurrent Consumption6.6 mA @ 2.5V; 8.6mA @ 3V; 16.6mA @ 5VImpedance50 OhmsGainAt 90dev vertical to sky 30 +/- 5 dBi
Quadruple-Band base station and marine antenna – four bands with only one antenna.
Covering both GSM/NMT-900, DCS-1800/PCN (GSM 900/1800) PCS-1900 and UMTS.
Particularly suitable for use with triple-band mobile phones.
Unity gain on all bands.
Simple mounting using the 1” revolving nut system.
Wide variety of accessory mounting brackets available.Homepage: https://amphenolprocom.com/products/base-station-antennas/547-cxl-900-1800-1900-umts
The CXL 2400-1/… is a 0 dBd, vertically polarized, omnidirectional
rod-type base station and marine antenna for the 2400 MHz band.
The 1” revolving nut mounting system is standard throughout the
marine sector, and several different mounting brackets are available,
making it possible to install the antenna either on the masthead using
FLG or SMR 2, side-mounted on the mast (SMR 1) or mounted on a
cross-beam (FLG). Also, the antenna can be mounted on deck or rooftop by
means of the FLG.
The higher the antenna is mounted, the better coverage. Avoid
mounting the antenna parallel to or in the neighbourhood of other metal
parts, such as masts, supporting wires etc., otherwise the VSWR and the
radiation pattern may be strongly influenced.
A conical glass fibre tube completely encloses the carefully
designed radiating element to ensure long dependable service in all
Vertically polarized, omnidirectional base station and marine antenna.
Approximately 6 dBd gain.
Simple mounting using the 1" revolving nut system.
Wide variety of accessory mounting brackets available.
Highly suitable for duplex operation with large spacing between the Tx and the Rx frequencies.
The antenna element is sealed in a high-quality, conical glass fibre tube.
All metal parts in the antenna are DC-grounded to reduce the noise
caused by atmospherical discharge. Consequently, the antenna shows a
DC-short across the coaxial cable.
The CXL 5200-6 is a vibration-proof, lightweight, slim-line, corrosion resistant, modern style base station and marine antenna.
This is a small ISM band antenna with SMA connector, to be used for various applications.it
has the more gain in the PCS1900 and gsm850 bands than our regular
ant-sma-gsm antenna and is also very suitable to ISM applications in the
868MHz bandthe connector is a regular SMA female.the size is about 55mm x 9mm without connector, and 63mm x 18mm including connector.
This is a high-quality coaxial lightning protector from Times Microwave.Impedance50 OhmsFrequency RangeDC - 3 GHzInsertion Loss< 0.1dB: (DC - 1GHz)< 0.2dB (1GHz - 3GHz)Max average power210 WMax surge current20 kA multiple (8/20 us wave-form)Impulse sparkover700V (1kV/usTurn-on230 V DCTemperature-40 C to 85 CIngress ProtectionIP67 For more information see the data sheet and the installation instructionsNOTE: Mounting bracket is NOT INCLUDED